t 1.877.708.1184 f 604.708.1185 www.mplighting.com
16 West 4th Avenue, Vancouver BC V5Y 1G3, Canada
Copyright © MP Lighting. All technical information in this document is subject to change. 06-2011
1
1/2 to 3/8” (13 to 10mm)
of hex bolt screws should
remain above finished
concrete when positioning
mounting plate.
2
Attach conduit.
Clean using a soft cloth.
Maintenance
• Allen key
Tools
included
Parts Qty.
• LED unit
• Hex countersunk screw
• 1/4” x 3” Hex bolt screw
• 1/4” Hex cap nut
• RST waterproof connectors
• Conduit strain
relief connector
1
4
4
4
1
not
included
• Mounting plate 1
• Washers 4
915mm
36”
13 - 10mm
1/2 - 3/8”
114mm
4-1/2”
114mm
4-1/2”
915mm
36”
13 - 10mm
1/2 - 3/8”
3
Pull cabtire cable so
approximately 36”
(915mm) of cable
remains above
concrete.
Rough In
LED92
Installation
Instructions
Cabtire
Cable
• Read all instructions.
• WARNING: RISK OF FIRE OR
ELECTRICAL SHOCK: Do not
make or alter any openings in the
compartment of wiring or electrical
components during installation.
Do not alter or add ballasts, or any
other electrical components.
• Installation and use of this fixture
mounting assembly requires a
person familiar with the construction
and operation of luminaire electrical
systems and the hazards involved,
if not qualified, do not attempt
installation.
• Turn off power before installation.
• Connect to 700mA constant current
driver only.
• Avoid using detergents
with hand softeners, anti-bacterial
agents, glass cleaners or acrylic
cleaning products.
• KEEP THESE INSTALLATION
INSTRUCTIONS.
CAUTION
To Next Page
Need help?
General