Remote Control ( Esmitter ) Operation
If emitter can not control the fan
① ②
③
AAA 1.5V
1. IMPORTANT: Using a full range dimmer
switch(not included) to control fan speed will
damage the fan. To reduce the risk of fire or
electrical shock, do not use a full range
dimmer switch to control the fan speed.
(Figure 1)
2. Restore electrical power to the outlet box
by turning the electricity on at the main
fuse box. (Figure 2)
!
Check to see that all connections are tight,
including ground, and that no bare wire is
visible at the wire connectors, except for the
ground wire.
WARNING
!
Do not operate this fan with a variable
(Rheostat) wall controller or dimmer switch.
Doing so could result in damage to the ceil-
ing fan's remote control unit.
1.Please check whether the battery
is installed correctly and whether it
is charged.if necessary, replace the
remote control battery
2.Please check if there are similar
remote control products working
nearby. because remote control
products of the same frequency will
interfere with each other.
WARNING
How to operate your ceiling fan
Figure 1
Figure 2
main fuse box
for illustrative purpose only-not
intended to cober all types of controls
ON OFF
+
-
K- K+
To Next Page
Loading...
