Other buttons (Lower section)
The lower section of the remote contains flat membrane-type buttons that are embossed
around their edges to make them easy to identify by feel.
Some buttons contain two text colours. The red text is the default function; pressing the
button by itself will cause it to perform that function. The function in blue text is initiated by
first pressing the blue “2
nd
F” button.
Mov/Sta: Toggles the radar between moving and stationary operating modes.
Stopw: Activates stopwatch mode (“2
nd
F” button must be pressed first).
Test: Manually initiates a radar self-test. The radar will momentarily illuminate all displays
and icons followed by simulated speeds. If no problems are detected it will return to the
previous mode of operation. If a problem is found the radar will display “Err” (error) and
cease the speed measurement process.
POP
Note: Never activate Test during target acquisition.
The radar also performs internal self-checks during normal operation (initiated
automatically). If operating correctly a double beep will be heard or alternatively,
“Err” (error) if a problem is found.
Pat Bl: When in Standby mode, pressing the “Pat Bl” button will clear the patrol speed
display. (“2
nd
F” button must be pressed first). Pressing “Pat Bl” a second time will
cause the locked patrol speed to reappear.
Low/Hi: Selects the City or Highway filter and determines the low end patrol speed. “Ci”
(City mode) or “Hi” (Highway mode) appears in the patrol window while in
Standby.
– Once pressed a “P” appears in the middle window. POP + must be selected to
POP
enter into POP mode. It also functions with the “Menu” button. If a menu
selection has been made it will decrease the setting.
Menu: Facilitates the selection of modes and settings that do not have individual buttons on
the remote. For further information see the Menu section of this manual.
– Direct entry into POP mode. It also functions with the “Menu” button. If a
menu selection has been made it will increase the setting.
To Next Page
Loading...
