14
ELECTROSTATICS
While vacuuming certain surfaces in low air humidity conditions, the
appliance can become slightly electrified. It is a natural phenomenon.
It does not damage the appliance and does not form the defect of the
appliance. In order to minimise this phenomenon, it is recommended
to:
discharge the appliance by frequent touching of metal objects with
pipe in a given room,
increase the air humidity in the room,
apply the publicly available antistatic agents
ACCESSORIES
A. MOTOR SET
The section encompasses the motor, ON/OFF switch and working ele-
ments. On top of this section there is a HEPA 13 filter used for separat-
ing dust residue and other tiny particles from exhaust air.
A1
ON/OFF switch button
A2
Power cord rewind button
A3
HEPA 13 filter
A4
HEPA 13 filter cover
A5
Air inlet
A6
Handle
A7
Rubberised wheels
A8
Parking clip
A9
Power cord with plug
A10
Housing
B. CONTAINER
The section encompasses the water filter container with components
used for collecting impurities. The container is placed on the housing.
B1
Transparent water container – 1.2L
B2
Water container lid
B3
Water container handle
B4
DWS diffuser (for dry vacuuming only)
B5
Motor protection filter
B6
Floating nozzle (for wet vacuuming only)
C. HOSE
The section encompasses the suction hose with grip and suction
pipes. The suction end is connected with the container section by in-
serting the hose into the suction inlet. The suction pipe is connected
with the grip. The grip contains the suction power control. The hose
can be placed on the motor set by means of the parking clip.
C1
Elastic suction hose
C2
Metal telescopic tube
D. ADDITIONAL ACCESSORIES
There are many available accessories for various cleaning needs:
D1
Accessories holder
D2
Floor and carpet nozzle
D3
Crevice nozzle
D4
Round brush
D5
Narrow brush
D6
Air refresher