16
from the mains socket and rewind the power cord by pressing the
cord rewind button
A2
.
4. Carry the vacuum cleaner by holding its handle
A6
.
CAUTION: In the dry vacuuming mode vacuum dry surfaces only. If there is
a foam in the container (e.g. as a result of sucking in foaming substances),
turn off the appliance and change the water immediately.
WET VACUUMING
1. Install the floating nozzle
B6
in your vacuum cleaner in the place of
the diffuser
B4
and do not pour the water into the container
B1
.
2. During wet vacuuming the vacuum cleaner can suck in the water. The
suction of solid fractions should be limited because in this mode it is
the suction of water, e.g. incidentally spilled on the floor or left after
cleaning the floorings and floors, etc., that forms the priority for the
vacuum cleaner.
3. For wet vacuuming use the narrow brush
D5
, after the prior removal
of hair from it, or the crevice nozzle
D3
. Do not suck in the water with
other nozzles.
4. After turning on the appliance, vacuum the wet surfaces. Suck in only
the water with the application of the vacuum cleaner. Do not suck in
other liquids.
5. After sucking in 2.7l of water the float will close the suction port and
the water will cease to be sucked in. Turn off the vacuum cleaner in
such a situation, disconnect it from the mains and remove the water
from the water container.
CAUTION! Do not suck in more than 2.7l of water. The excess water can lead
to the failure of the appliance. Empty the water container regularly.
CLEANING AND MAINTENANCE
CAUTION! Do not use sharp items, abrasive pastes, solvents and other strong
chemical agent for cleaning – their use can damage the appliance.
CAUTION! In order to achieve the best efficiency of the appliance, clean the
filters and water container after each use.
CAUTION! Do not install wet filters – it forms the vacuum cleaner damage
risk.
CAUTION! Prior to performing any maintenance or cleaning activities, al-
ways turn off the appliance and unplug it from the mains socket. Do not im-
merse the appliance in water!
1. After each use remove the water from the water container. Clean
and dry the container.
2. Never leave the vacuum cleaner with dirty water inside the water
container. Moisture and impurities can give rise to unpleasant smells
inside the container and adversely affect further use of the appliance.
3. Remove the diffuser
B4
and clean it under warm running water with
detergent. Remember to clean the DWS diffuser ports thoroughly..
4. Check the cleanliness of HEPA 13 filter regularly. The filter can be
cleaned under running water. After a longer period of using, the filter
loses its properties. Then, it is necessary to replace it with the new
one.
5. Periodically remove the sponge silencer insert from the HEPA filter
(option), rinse it clean in water and leave until completely dry. Next,
reinstall it in the HEPA filter.
6. Periodically remove the motor protection filter
B5
from the vacuum
cleaner, rinse it in water and dry it. Replace it every 6 months.
7. To maintain the warranty rights, ensure the safety and satisfaction
associated with using the appliance, use only original parts and ac-
cessories.
To Next Page
Loading...
Need help?
General
