17
EN
USAGE INSTRUCTIONS
1. Place the appliance on a rm, level and dry surface.
2. Plug the power cord to the mains. A short sound signal will be played, and the display (2h) will
show the “L” status. Keyboard operation will always produce a sound signal.
3. Place a compatible pan on the heating zone (1). Any attempt to start the heating process
without a pan on the heating plate or with an incompatible pan will result in the “EO” error
code on the display (2h).
4. Turn on the appliance using the on switch (2a) and press the “Menu” button (2c) to go
to heating parameter selection. If you take no action after turning on the hob, it will
automatically turn o after 30 seconds.
HEATING POWER – use the function selection touch button (2c) to select heating power – “P”
LED will light up, indicating that heating has begun. Use parameter adjustment touch buttons
(2d) to select adequate heating power. The following power settings are available: 200, 350,
500, 650, 800, 1000, 1200, 1400, 1600, 1800 W. The higher the power, the faster the cooker
heats up, which ultimately means that meals can be prepared more quickly. The power can be
re-adjusted at any time.
HEATING TEMPERATURE – if you want to heat the meals according to temperature, use the
function selection touch button (2c) to select temperature – a LED will light up (°C), indicating
that heating has begun. Use parameter adjustment touch buttons (2d) to select adequate tem-
perature. The available temperature settings are: 60, 80, 100, 120, 140, 160, 180, 200, 220, 240
°C. The temperature can be re-adjusted at any time.
CAUTION! If you do not declare the heating time, the appliance will automatically switch o after 120 minutes.
HEATING TIME – from 0 to 180 minutes. Use the timer function touch button (2g) to select the
timer – a LED will light up over the touch button Use the touch buttons (2d) to set the heating
time in minutes (“+” adds 10 minutes, while “-” reduces the time minute by minute) and while a
moment – the congured value will be lit up continuously, which means the timer has started
working. The cooker will then alternately display the passing time and power or temperature.
Once the congured time is up, the heating plate will be deactivated and a sound signal will
be heard.
5. The cooker’s keyboard can be locked. To lock the keyboard press, at the same time, the two
touch buttons for changing parameters (2d). Blocking will be signalled with a LED light below
the padlock icon. Press and hold both touch buttons (2d) for 3 seconds to lock and unlock the
keyboard.
6. If you lift the pot/pan or move it away from the cooking zone, the heating process will stop
automatically (“EO” message). The hob will resume the process using the previous settings
if you put the pot/pan back on the heating zone within 60 seconds. Otherwise the hob will
switch o automatically.
7. You can stop the heating process at any moment using the “ON/OFF” button (2a).
CAUTION! The heating plates can be hot after use. Do not touch.
To Next Page
Loading...
Need help?
General
