12
GB
STATIC ELECTRICITY
Vacuum cleaning certain surfaces at a low air humidity may cause slight electrification of the
appliance. This is natural, does not damage the appliance and does not constitute its defect.
To minimise this phenomenon, it is recommended to:
frequently discharge the appliance by touching items in the room with the metal pipe,
increase air humidity in the room,
use generally available anti-electrostatic products.
APPLIANCE ASSEMBLY
1. Press both latches on the suction hose mounting ring (17), insert the ring into the opening (7)
and release the latches. To disassemble, press the latches again and remove the ring (17) from
the opening (7).
2. Connect the other side of the suction hose (18) to the handle (19) and connect the metal
telescopic wand (16) to the other side of the handle (19). Install one of the tools, (20) or (21),
on the end of the wand.
USING THE APPLIANCE
1. Before turning on the vacuum cleaner, unwind the power cord (9) to a suitable length and
plug it into the mains socket. The yellow mark on the power cord indicates the optimum
length. Do not pull out the cord beyond the red mark! While unwinding the cord, do not
press the cord winder button (23).
2. Press the switch (1) to turn on the vacuum cleaner.
3. To wind the power cord, press the cord winder button (23) with one hand, while holding the
cord with another hand to prevent a sudden movement that could damage it.
Note! It is recommended to set the suction power control (1) to MIN before turning on the vacuum cleaner!
When at work, you can regulate the suction power by moving the suction power control left or right to a suita-
ble position.
Dust bag filling level indicator light turns red when the suction hose is clogged or the dust bag is full. You need
to replace the dust bag or remove the clogging from the suction hose.
4. To ensure optimum appliance setting upon the completion of work, use the guide (3) in the
rear of the vacuum cleaner. Place the rail in the rear of the floor-carpet attachment with con-
nected suction hose and telescopic pipe on the guide. The second guide that facilitates vacu-
um cleaner storage in the vertical position is under the bottom of the appliance.
ACCESSORIES OVERVIEW
FLOOR-CARPET ATTACHMENT
Designed for cleaning large flat surfaces. It is equipped with castors that facilitate movement
in difficult to access places and a flexible joint, connecting it with the suction hose, which
allows directing at various angles. When you press the button on the upper attachment ho-
To Next Page
Loading...
Need help?
General
