EasyManuals Logo
Home>MPM>Vacuum Cleaner>MOD-35

MPM MOD-35 User Manual

MPM MOD-35
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
15
GB
- press the hinge cover release button (29) and empty the contents of the canister into the
waste bin
- close the hinged cover (9)
- turn on the appliance and resume vacuuming.
8. After the vacuuming is complete, turn off the vacuum cleaner with the switch (3), clear the
dust canister and charge the battery. A fully charged battery provides up to 30 minutes of op-
eration at low suction level. Apart from the battery charge indicator (6a), the vacuum cleaner
will signal the necessity of recharging by a significant loss of suction power.
PARKING THE VACUUM CLEANER IN THE WALL MOUNT
The MOD-35 vacuum cleaner includes a wall parking
mount (28) for easy and space-saving storage. Install
the wall parking mount on a wall to use it:
1. Choose a place on a wall high enough above the floor
so that the vacuum cleaner fits parked and with its
telescopic wand and electric brush. Make sure there
is no wiring in the wall within the envelope of the wall
parking mount.
2. Place the parking mount (28) on the wall and mark
the hole positions (A, B, C) with a pencil – fig. 4.
3. Drill the holes at the marked locations, insert the wall
plugs, place the parking mount (28) and secure it
with screws. Now, you can park and store the vacuum
cleaner on the mount .
CLEANING AND MAINTENANCE
CAUTION! Never immerse the vacuum cleaner, the battery charger, the battery or the battery dock in water!
CAUTION! Empty the dust canister and clean the filters after each use for the best performance.
CAUTION! Maintain the vacuum cleaner powered off and disconnected from the battery charger!
1. Clean the outer surfaces of the vacuum cleaner with a damp cloth and wipe them dry. Use a
bit of a neutral detergent to remove persistent dirt.
2. Empty the dust canister, detach the filter cage (12), take out the cloth filter (10) and gently
remove the sponge filter (11). Remove the HEPA filter (13) as well. Rinse all the filters and the
filter cage (12) under running water and then dry completely before inserting into the vac-
uum cleaner.
3. In order to thoroughly clean the dust canister, you can separate the dust canister body (7)
from the bottom part of the canister (8) by gently twisting the two parts (see: markings on
the canister). Wash the bottom part of the canister (8) in water with mild detergent, rinse and
dry completely before assembly.
CAUTION! Do not install any filter when not dry: the vacuum cleaner can fail!
4. Recharge the battery after each use. Do not store the vacuum cleaner with the discharged
battery. Use the supplied battery charger only. Do not short the battery poles. Use the iden-
tical battery type for replacement.
A B
C
Fig.4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MPM MOD-35 and is the answer not in the manual?

MPM MOD-35 Specifications

General IconGeneral
BrandMPM
ModelMOD-35
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals