12
GB
APPLIANCE ASSEMBLY
1. Press both latches on the suction hose mounting ring (19), insert the ring into the open-
ing (10) and release the latches. To disassemble, press the latches again and remove the ring
(19) from the opening (10).
2. Connect the wand (20) to the handle (18). Install one of the tools, (21) or (22), on the end of
the wand.
3. The length of the telescopic suction pipe (20) can be changed by pressing the button in the
middle part of the suction pipe.
USING THE APPLIANCE
1. Before turning on the vacuum cleaner, unwind the power cord (11) to a suitable length and
plug it into the mains socket. The yellow mark on the power cord indicates the optimum
length. Do not pull out the cord beyond the red mark! While unwinding the cord, do not
press the cord winder button (2).
2. Press the switch (1) to turn on the vacuum cleaner.
3. To wind the power cord, press the cord winder button (2) with one hand, while holding the
cord with another hand to prevent a sudden movement that could damage it.
4. Setting the correct sucking power of the vacuum cleaner:
a. In the MOD-50 model, slide the regulator (3) to the desired position:
b. In the MOD-51 model with +/- buttons on the regulator (3), set one of the five available
power levels. The icons on the panel indicate preset power levels for various surfaces to
be vacuum cleaned:
draperies, curtains
upholstered furniture, pillows
carpets, carpeting
floor panels, heavily dusted carpets
hard flooring, heavily dusted items
NOTE!!! For the MOD-50 model, it is recommended to set the suction regulator (3) to MIN before switching the
vacuum cleaner on!
To Next Page
Loading...
Need help?
General
