MPM MPM-116-CJI-17/E - Page 26

26
EN
FOR REFRIGERATING APPLIANCES WITH CLIMATE CLASS:

extended temperate: ‘this refrigerating appliance is intended to be used at ambient tem-
peratures ranging from 10 °C to 32 °C (SN);

temperate: ‘this refrigerating appliance is intended to be used at ambient temperatures
ranging from 16 °C to 32 °C (N);

subtropical: ‘this refrigerating appliance is intended to be used at ambient temperatures
ranging from 16 °C to 38 °C (ST);

tropical: ‘this refrigerating appliance is intended to be used at ambient temperatures ranging
from 16 °C to 43 °C (T);
Appliances must not be exposed to rain.Sufficient air must be allowed to circulate in the lower
rear section of appliances, as poor air circulation can affect performance. Built-in appliances
should be positioned away from heat sources such as heaters and direct sunlight.
A deviation of –6V to +6V is admissible with respect to the rated voltage. For operation with
other voltage supplies, a right autotransformer is required.
Always connect the appliance to an useful earthing system For the above,if the main supply is
not earthed,connect the appliance to a separate earthing system. Consult a specialized tech-
nician to carry out the latter in compliance with current standards.
The manufacturer declines all responsibility for failure to observe the above accident preven-
tion standards.
CLEANING THE INTERIOR PRIOR TO USE
Prior to use, clean all internal parts with warm water and neutral detergent to remove the
“new” odor and dry thoroughly. Never use abrasive detergents and/or powders that can dam-
age the appliance.
INSTALLATION INSTRUCTIONS:
Before installing, carefully read the instruction in order to avoid a certain number of problems..
PARTS LIST:
• Install part E and replace the bottom cover.
>200cm²
！
80 ~ 10 0
min 5 50
600
130
595
820 ~ 9 00
818 ~ 8 98
100 ~ 1 80
164 ~ 2 44
A-B
A
+8
01
02
03
04
05 06
07
08
130
x 2
x 2
x 2
x 2
G
x 12
x 2
x 1
x 1
H
I
x 1
• Tools you may need:
• Dimensions of mounting slot.
• Fastening the appliance under the worktop
and replace the covers(install part G).
• Replace the covers(install part H and I)
and recover the kitchen worktop bottom cover.
• Mounting and adjust the kitchen cabinet door
(install part C ).
• Mounting the kitchen cabinet door
(install part D).
• Remove the covers and install part A and B .
• Height regulation and put the appliance into
the worktop.
(Accessories package)
G
H
I
E
600
97 ~ 17 7
B