33
EN
OPERATION AND FUNCTIONS
CHANGING THE LED BULB
Warning!
Changing the LED bulb carry out by inexperienced persons may cause injury or serious mal-
functioning. It must be replaced by a qualified persons in order to avoid a hazard. Contact
your local Service Force Center for help.
Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or the
circuit breaker.
LED bulb data: 220-240V, max.1.5W.
Unplug the mains plug. To change the light bulb, undo the screw. Press the light bulb cover
and slide it backwards. Pull out the Lampholders fixed block. Change the defective light bulb.
Push back the LED bulb to the bottom, insert the Lampholders fixed block into the slot. Refit
the light bulb cover and the screw.Put the refrigerator back into operation.
This product contains a light source of energy efficiency class G.
If LED lighting does not work, call a service technician.
Do not attempt a repair of the LED lighting yourself, as there is danger of contact with high
voltage
NOISES DURING OPERATION
The following noises are characteristic of refrigeration appliances:
Clicks
Whenever the compressor switches on or off, a click can be heard.
Humming
As soon as the compressor is in operation, you can hear it humming.
Bubbling
When refrigerant flows into thin tubes, you can hear bubbling or splashing noises.
To Next Page
Loading...
