8
EN
WARNING Do not allow children to play with plastic foil. Danger of
asphyxiation.
For the safety of children, never leave any packaging materials laying around, such
as plastic bags, boxes, polystyrene, etc.
Caution Never cover the heater during operation. This may
cause the temperature inside the device to raise to dangerous
levels.
DESCRIPTION OF THE DEVICE
4
8
5
1
3
7
6
2
1. Side wall
2. Feet
3. Handle
4. Thermostat knob
5. Air grille
6. Mode switch: 1, 2, 3 + blow
7. Blow grille
8. Status control light
PREPARING THE CONVECTION HEATER FOR USE:
1. Remove the device from packaging.
2. Install the feet by sliding the into clips and then screw them in.
USING THE CONVECTION HEATER:
1. Plug the device to the power source with ground.
2. Set the thermostat knob at MAX.
3. Set the desired heating power according to the following information:
• Position 0 — off
• Position I — max. heating power 800 W
• Position II — max. heating power 1200 W
• Position III — 2000 W
To Next Page
Loading...
