9
EN
or when using the blow function:
• Position I
— 800 W heating power
• Position II
— 1200 W heating power
• Position III
— 2000 W heating power
•
blow
The convection heater had a thermostat knob. Using the knob you can set the desired temper-
ature. After reaching the desired temperature level in the room, move the thermostat knob in
the opposite direction until the switch lamp goes off. The temperature set previously will be
maintained using the thermostat: when the temperature in the room drops, the convection
heater will activate automatically and after reaching the preset temperature again, it will stop.
CAUTION DO NOT PLACE THE CONVECTION HEATER OR INSTALL ON WALLS NEAR FURNITURE, CURTAINS, DRAPES,
ETC. NEVER COVER THE VENTILATION GRILLE ON THE DEVICE.
CLEANING AND MAINTENANCE:
1. Always unplug the device from the power source before cleaning.
2. The convection heater does not require any special maintenance activities provided it is used
in accordance with the instructions for use.
3. Do not use solvents and other strong cleaning agents for cleaning the housing as their use
will damage the coating on the housing. You can clean the housing using a damp cloth with
small quantity of detergent, and then thoroughly dry.
INFORMATION ON ELECTRICAL CONVECTION HEATER FOR ROOMS:
Parameter Designation Value Unit Parameter Unit
Heat output Heat supply method only with electric accumulation
heaters for rooms.
Nominal heat output Pnom 1.973 kW Manual heat supply controller with integrated
thermostat
n/a
Minimum heat
output (estimated)
Pmin 0 kW Manual heat supply controller with temperature
measurement in a room or outdoors
n/a
Maximum constant
heat output
Pmax,c 1.973 kW Electronic heat supply controller with tempera-
ture measurement in a room or outdoors
n/a
Electricity consumption for own needs Heat output adjusted with fan n/a
At nominal heat
output
elmax n/a kW Type of heat output/temperature control-
ler in the room
At minimum thermal
power
elmin n/a kW single stage heat output without temperature
in the room
NO
in standby mode elSB n/a kW At least two manual stages without temperature
adjustment in the room
NO
Mechanical temperature adjustment in the room
using thermostat
YES
Electronic temperature adjustment in the room NO
To Next Page
Loading...
