Mpow BH298A User Manual

9.Voltage Protection Function
BH298 is only allowed to charge with SV. When using a non-standard charger, BH298 is automatically
protected with the indicator light OFF. When the charger is correct, BH29B will automatically resume charging
with the
red indicator light steady on.
10.Automatic Power-saving Function
1. After BH298 is connected successfully, the indicator light will go off after S s to save power; Short press any
button to activate indicator light
2. If BH298 is in power-on state without Bluetooth device connected for 10 minutes, it will power off automatically
with the indicator light going off.
NOTE , For the next use, you should tum the ON / OFF switch to •oFF" before turning ~ on.
11.Considerations
1. If BH298 cannot be paired with Bluetooth devices, please reboot BH298 and try pairing again.
16
2. To complete the Bluetooth pairing, it's recommended to use BH298 in the place where there are few
obstructions or other Bluetooth devices working.
3. If the pairing fails:
A:. Please clear the pairing list on BH298 and smartphones etc. and try pairing again.
B: Meanwhile, please check whether BH298 is in Bluetooth pairing mode.
C: Also, you'd better turn off other Bluetooth devices nearby.
12.Warning
The product contains battery. During the operation, please pay attention to the following information:
1. Acceptable operating temperature range: 0-45°C / 32- 113 °F.
2. Please avoid using or charging it in high temperature, low temperature or static environment (such as cars
exposed to direct sunshine in hot weather, fire, surface with high temperature or extreme cold environment).
Otherwise, it may influence the performance or lifespan of the battery.
3. Charge it via a STANDARD 5 V charger.
17

Mpow BH298A Specifications

General

Brand	Mpow
Model	BH298A
Category	Receiver
Language	English