© 2022 mPTech. All rights reserved. Halo 3
29
Pairing bluetooth devices
To connect to a Bluetooth device, select it from the list of available devices by going
to [Menu] > [Settings] > [Bluetooth] > [My device] > [Search new device], then select
a device from the list and press [Pair]. Both devices will display a message asking you
whether your password is compatible or correct. Enter the same data on both devices
or confirm compatibility and press [OK] to pair the devices.
Sending files via Bluetooth
To send files situated on the memory card to a paired (connected) device enter:
[Menu] > [Organizer] > [Files] > [Memory card] or [Phone] and choose a file you want
to send. Then choose [Options] > [Send] > [Bluetooth] and search the device you wish
to send the file to or add it from the list of paired devices. The file will be send after
recipient’ approval.
Troubleshooting
Make sure SIM card has been correctly installed.
If the SIM card is secured with the PIN code you have to
enter the PIN when turning the phone on and press
<OK>.
In areas where signal or reception is weak, calls may not
be possible. Also receiving calls may not be possible.
Move to another location and try again.
The phone has to be on and within GSM network reach.
I cannot hear the
caller./The caller
cannot hear me.
The mic. should be close to mouth.
Check if the built-in mic. is not covered.
When a headset is un use, check if it has been connected
correctly.
Check if the built-in speaker isn’t covered.
Poor sound quality
while on the phone.
Make sure that the speaker and mic. are not covered.
The connection cannot
be established.
Check if the typed-in phone number is correct.
Check if the phone number entered to the [Phonebook]
is correct.
Enter the correct phone number if necessary.
If the problem persists, contact service center.
5. Proper phone maintenance.
Proper use of the battery
Battery in this device can be charged with a charger. If the battery level is low, charge
it. To prolong battery life, let it discharge beneath 20% of the battery capacity before
connecting the charger and charge it up to 100%. If not used, unplug the charger from
the phone and power grid. Overcharging or leaving in a too low/too high temperature
or within magnetic field may shorten battery life cycle. The temperature of the battery
has an impact on its charging cycle. Cool the battery or raise its temperature so that
it is similar to the room temperature (approx. 20°C/68°F). If the battery temperature
exceeds 40°C/104°F the battery must not be charged! Use the battery only according
to its intended purpose. Do not use a damaged battery. Do not throw the battery into
flames! Do not throw a worn-out battery – send it or return it to an authorized recycling
point.
To Next Page
Loading...
