MQ Multiquip WHITEMAN B Series

Questions and Answers

G
George BakerAug 12, 2025
How to troubleshoot an MQ Multiquip WHITEMAN B Trowels engine that is running rough?
- J
  Jasmine MckeeAug 12, 2025
  If your MQ Multiquip Trowel engine is running rough or not at all, there are several things to check. First, ensure the killswitch is in the ON position; if it's faulty, replace it. Next, inspect the fuel system to confirm fuel is reaching the engine and that the fuel filter isn't clogged. Finally, verify that the ignition switch is receiving power and functioning correctly.
K
Kimberly GonzalezAug 19, 2025
What to do if MQ Multiquip WHITEMAN B Trowels clutch is slipping?
- C
  Cody JacksonAug 19, 2025
  If your MQ Multiquip Trowel experiences clutch slipping or sluggish response, several factors could be at play. Start by checking the V-belt for wear and replace if necessary. Inspect the centrifugal clutch for dirt and clean it if needed. If the clutch is defective or worn, replace it entirely. Also, examine the hand clutch for proper adjustment. If the gearbox shaft rotates with difficulty, check the input and output shaft bearings and replace if necessary. Finally, verify that the gearbox shaft rotates when the input shaft is rotated; replace both the worm and worm gear as a set if there are worn or broken gears in the gearbox.
M
Maria BrockAug 27, 2025
Why MQ Multiquip WHITEMAN B has a rolling motion while running?
- Y
  ymorganAug 27, 2025
  If your MQ Multiquip Trowel has a perceptible rolling motion while running, check the main output shaft of the gearbox assembly for straightness, ensuring it's no more than 0.003" (0.08 mm) out of round at the spider attachment point. Also, make sure that both fingers of the yoke press evenly on the wear cap, replacing the yoke if necessary. Finally, ensure each blade is adjusted to have the same pitch as all other blades.