4
During the cleaning process, you can
hear the intermittent (approximately
5 seconds) vibrating sound when you
take the fuel injector out and put it to
your ear, so you can judge whether
the fuel injector is working normally.
Ultrasonic cleaning is strictly
prohibited when there is no cleaning
agent in the ultrasonic tank to avoid
equipment damage.
Only the ultrasonic cleaning agent
dedicated to cleaning the fuel
injection nozzle can be added to the
ultrasonic tank, and other reagents
cannot be used instead,
otherwise any malfunctions and
damages caused will not be covered
by the warranty.
NOTICE：
This function is to detect the atomiza-
tion, dripping, blockage, fuel injection
angle status of the fuel injectors and
the size and balance of the fuel
injection of each fuel injector at
different speeds.
3.2 Injector Diagnostic
Add an appropriate amount of
cleaning agent to the ultrasonic
tank and spread the cleaning agent
over the bottom of the cleaning
stand.
Insert the plugs of the drive wires
into the injector sockets in turn.
(Special fuel injectors need to be
connected with an adapter cable)
Press the item selection up and
down keys to select the “01
ultrasonic cleaning" item, and then
press the working time up and
down keys to set the time. (The
system defaults to 10 minutes, if
you need to modify the time, you
can use the up and down keys to
change)
Press the start button and turn on
the ultrasonic cleaning switch on
the side of the device to start
cleaning. When working, you can
press the pause button to suspend
work or press the stop button to
exit.
During the cleaning process, the
heating switch on the side of the
equipment can be turned on to
improve the cleaning effect.
The working time gradually decreas-
es. When it is 0, the system automat-
ically stops.
Take out the fuel injection nozzle
from the ultrasonic tank, wipe the
cleaning liquid on it with a soft cloth,
and prepare for the next job.
Methods And Steps
Turn on the power and turn on the
power switch on the side of the
main unit.
Put the cleaning bracket in the
accessories into the ultrasonic
cleaning tank, and place the wiped
fuel injector in the cleaning bracket
positioning hole of the ultrasonic
tank.
To Next Page
Loading...
