To Next PageTo Next Page
Need help?Do you have a question about the mr. steam CU-2500 and is the answer not in the manual?
General| Brand | mr. steam |
|---|---|
| Model | CU-2500 |
| Category | Portable Generator |
| Language | English |
Warning against altering or modifying products.
Indoor, dry, clean location, away from flammables.
Locate steam heads away from seating and traffic.
Multiply Length x Width x Height to find volume.
Consult architect/designer; select next larger volume.
Specifies minimum clearances for installation and servicing.
Specifies minimum clearances for installation and servicing.
Specifies minimum clearances for installation and servicing.
Performed by qualified plumber, follow codes.
Connect to water line, install shut-off, check pressure.
Use brass/copper, pitch line, insulate.
Lists recommended limits for hardness, alkalinity, pH.
Install steamhead 12-30 inches above floor, use acrylic shield.
Disconnect power, use qualified electrician, follow codes.
Use proper conductors, grounding, and dedicated circuits.
Follow National/local codes and wiring diagrams.
Install safety switch with adequate capacity breakers/fuses.
Safety switch, room requirements, sensor placement.
Digital 1 system is required; set temperature at owner's discretion.
Sensor placement and timer/control settings are owner's discretion.
Mount the Digital 1 control panel and connect control wires.
Locate sensor 5 ft above floor, away from steam heads.
Digital 1 controls temp; pressure controls maintain set pressure.
Instructions for installing the automatic blowdown kit and programming.
Step-by-step procedure to test the blowdown system.
How to set the operating temperature on the Digital 1 control.
Lists possible messages and their meanings.
Safe installation of the 30-minute timer.
Warnings about overheating, scalding, slipping, and signage placement.
Checks for water supply, switches, and LWCO operation.
Common causes and remedies for no water or heating issues.
General steps for troubleshooting, including voltage checks and override switch.
