When do i select “Reverse State” ?
Mr12volt detects car CAN bus with most of the car models in the market,
however in some cases particularly in older generation cars, when a CAN bus
can’t be detected, it is necessary to manually detect camera through car
reverse light signal.
(Refer to the AUDI MMI 3G Installation Diagram for more details )
“Starting front view” -
Front camera timer setting with 5s, 10s, 30s
“Dedicated right view” - L/R Side camera setting (Blind Spot camera)
Can Active - Detects through CAN bus
12v Active - Detects through 12v side L/R light
“Reverse track”
- Option to turn ON / OFF of a Parking Grid (For AfterMarket
camera only)
“Reverse radar” - Option to turn ON / OFF of a Reverse Sensor (For
AfterMarket Reverse sensor only)
To Next Page
Loading...
