Mrcartool S300 - Product Installation

Product Installation
Before powering on, check again whether the power cable is damaged.
After the first step is completed, insert the power supply plug of the charging box
into the power supply socket, and check whether the power indicator light stays
green. If there is no light, please check whether the socket is powered on, and
carefully check whether the plug is f irm.
Insert the charger into the charging stand of the electric vehicle and double check
that it is inserted in place to ensure a reliable connection.
Check to see if the status light on the portable charging case is flashing green.
When the status indicator is flashing green, it means the charging connection is
normal, and it can enter the charging state, and the charging status indicator will
flash green.
4
- If there are no further actions, the settings menu will automatically exit after 5
seconds.
4) Timer Setting: Press “SET” briefly to highlight “Set Timer” (the font will enlarge),
then press “OK” to enter the timer setting interface.
- Press “SET” shortly to select the desired duration. There is a gear every 30
minutes, and the longest setting is 480 minutes. The default is 0min.
- After selecting the desired duration, press “OK” to confirm and exit the timer
setting interface, returning to the settings menu.
- If there are no further actions, the settings menu will automatically exit after 5
seconds.
5) Ground Detection Setting: Press “SET” briefly to highlight “Earth (Ground)” (the
font will enlarge), then press “OK” to enter the ground detection setting interface.
- Press “SET” briefly to select either “Earthing” (requiring ground detection) or
“NO Earthing” (disabling ground detection).
- After selecting the desired option, press “OK” to confirm and exit the ground
detection setting interface, returning to the settings menu.
- If there are no further actions, the settings menu will automatically exit after 5
seconds.
6) Press and hold “SET” for 5 seconds to exit the settings menu.
Note: Set the parameters before charging to avoid potential charging failures.