Need help?Do you have a question about the MrCool A-18-HP-C-230A and is the answer not in the manual?
General| Cooling Capacity (BTU) | 18000 |
|---|---|
| HSPF Rating | 10 |
| Refrigerant | R410A |
| Compressor Type | Inverter |
| Phase | 1 |
| HSPF | 10 |
| Type | Mini-Split |
| Voltage | 208-230V |
| Operating Temperature Range (Cooling) | 5°F - 122°F |
| Outdoor Unit Dimensions (H x W x D) | 31.5 x 35.4 x 12.6 inches |
Covers warnings, cautions, and general safety advice for installation and operation.
Standards for selecting an appropriate installation location, including air circulation and drainage.
Identifies unsuitable locations such as near heat sources or obstacles.
Step-by-step instructions for securely attaching the unit's mounting plate to the wall.
Guidance on drilling the wall hole for piping, including size and angle requirements.
Important safety warning regarding potential hazards during wall drilling.
Steps to prepare refrigerant piping, including cutting and bending.
Safety warning to avoid damaging refrigerant piping while bending.
Steps for attaching and securing the drain hose for effective water removal.
Crucial notes on arranging the drain hose to ensure proper drainage and prevent traps.
Mandatory regulations and codes to follow for all electrical wiring.
Essential safety instruction to turn off power before any electrical or wiring work.
Detailed steps for connecting the signal cable between units.
Strict adherence warning for wiring diagrams on the unit's cover.
Detailed steps for hooking and securing the indoor unit onto the mounting plate.
Standards for choosing an appropriate installation site, considering space and ventilation.
Lists unsuitable locations for the outdoor unit, such as near obstacles or public areas.
Steps for installing the drain joint at the bottom of the outdoor unit.
Specific instructions for drain hose placement in cold climates to prevent freezing.
Steps for securing the outdoor unit to the ground or a wall bracket.
Crucial safety warning to wear eye protection when drilling concrete.
Steps to connect the signal and power cables to the outdoor unit's terminal block.
To Next Page
