MrCool Universal Series User Manual

Page 24mrcool.com
Unit Installation
Sealed
Saddle
Drain
Pipe
Trap
Drain
Pipe
If the outdoor unit is located on a level lower
than the indoor unit, arrange the condensate drain
according Fig. 2.21.
1. Drain hose should be placed on the ground
and its end should not be immersed into water.
2. The entire lineset, including drain pipe should
be wound with insulating tape. Wind the insulating
tape from bottom to top.
3. The entire lineset, including drain pipe should
be supported and fixed onto the wall with saddles.
If the outdoor unit is located on a level higher
than the indoor unit, arrange the condensate drain
according Fig. 2.22.
1. Drain hose should be placed on the ground
utilizing a trap
2. The entire lineset, including drain pipe should
be wound with insulating tape to avoid water
returning to the interior. Wind the insulating tape
from bottom to top.
3. The entire lineset, including drain pipe should
be supported and fixed onto the wall with saddles.
Installation of Drain Pipe
Fig. 2.21
Fig. 2.22

MrCool Universal Series Specifications

General

Type	Inverter
Brand	MrCool
Series	Universal Series
Refrigerant	R410A
Phase	1
Heating Capacity	Varies by model
Cooling Capacity	Varies by model
Compatibility	Universal
HSPF Rating	10
Voltage	208/230V
Operating Temperature (Cooling)	Varies by model
Operating Temperature (Heating)	Varies by model
Indoor Noise Level (dB)	Varies by model
Outdoor Noise Level (dB)	Varies by model
Indoor Unit Dimensions (H x W x D)	Varies by model
Outdoor Unit Dimensions (H x W x D)	Varies by model
Indoor Unit Weight	Varies by model
Warranty	5 years