QUICK START GUIDE
1
2
3 4
A: UNLOCK THE LATCHES.
B: OPEN THE MICROTRAP™.
INSTALL THE MICROTRAP™ SOFTWARE
ON THE COMPUTER.
A
A
B
A
B
TURN ON THE MICROTRAP™ BY TOGGLING
THE ON / OFF SWITCH AS SHOWN. THE
STATUS LIGHT WILL BEGIN TO FLASH.
PRESS THE BATTERY STATUS BUTTON TO
CHECK THE BATTERY LEVEL OF THE
MICROTRAP™.
PLUG THE COMMUNICATIONS CABLE INTO THE
MICROTRAP USB COM PORT.
THE LED WILL LIGHT UP INDICATING
THE LEVEL OF BATTERY AVAILABLE.
IN THE ABOVE EXAMPLE, THE
MICROTRAP™ IS AT 90%. IF THE
BATTERY LEVEL IS TOO LOW, PLEASE
SEE STEP 6 TO RECHARGE
MICROTRAP™, ELSE GO TO STEP 7.
PLUG THE BATTERY CHARGER INTO THE DC IN/OUT
CONNECTOR ON THE MICROTRAP™. PLUG THE OTHER
END OF THE BATTERY CHARGER INTO AC MAINS.
A: PRESS THE TOTAL TESTS BUTTON TO
VIEW THE TOTAL TESTS AVAILABLE ON
THE MICROTRAP™.
B: PRESS THE REMAINING TESTS BUTTON
TO VIEW THE REMAINING TESTS
AVAILABLE ON THE MICROTRAP™.
5
6 7
8
PLUG THE OTHER END OF THE
COMMUNICATIONS CABLE INTO THE
COMPUTER WITH THE MICROTRAP™
SOFTWARE INSTALLED. LOAD UP THE
MICROTRAP™ SOFTWARE AND CLICK THE
HIGHLIGHTED BUTTON ABOVE TO PROGRAM
THE MICROTRAP™.
9
WHEN THE ABOVE WINDOW APPEARS
CHOOSE THE TYPE OF TEST YOU WISH
TO PERFORM. IN THIS EXAMPLE, WE
CHOOSE VOD.
10
To Next Page
Need help?
General
