11 12 13
USING THE ABOVE WINDOW THAT OPENS,
SETUP THE MICROTRAP™ AS NEEDED. WHEN
FINISHED CLICK THE CHANGE SETTINGS BUTTON .
A: IF USING THE
MICROTRAP™
INTERNAL TRIGGER MAKE
SURE THE TRIG EXT/INT
SWITCH IS IN THIS POSITION.
B: IF USING AN EXTERNAL
MANUAL TRIGGER, MAKE
SURE THE TRIG EXT/INT
SWITCH IS IN THIS POSITION.
PRESS THE NEXT TEST BUTTON. STATUS LIGHT
WILL STOP FLASHING AND WILL REMAIN
ILLUMINATED (ACTIVE MODE).
WHEN READY TO CAPTURE THE VOD FOR THE
EXPLOSION, PRESS THE START BUTTON.
THE START LIGHT WILL REMAIN ILLUMINATED.
14
17
A: CONNECT THE COAXIAL CABLE TO THE VOD
CONNECTOR ON THE BACK OF THE
MICROTRAP™.
B: IF USING A MANUAL TRIGGER, CONNECT THE
TRIGGER TO THE EXT TRIG CONNECTOR.
SETUP THE VOD PROBEROD
OR PROBECABLE AS
NEEDED FOR YOUR TEST.
CONNECT THE PROBEROD
OR PROBECABLE TO THE
COAXIAL CABLE USING
WIRECUTTERS AND
ELECTRICAL TAPE.
18 19
WHEN THE
MICROTRAP™ HAS BEEN
TRIGGERED AFTER THE EXPLOSION,
THE TRIG’D LIGHT ON THE OUTSIDE
OF THE MICROTRAP™ WILL BEGIN TO
FLASH.
PLUG THE COMMUNICATIONS CABLE
INTO THE MICROTRAP USB COM PORT.
CONNECT THE OTHER END OF THE
COMMUNICATIONS CABLE TO THE
COMPUTER AND DOWNLOAD THE
VOD RESULTS.
1615
A
A B
B
To Previous Page
Loading...
