To Next Page

2 Unit Connection

! On test stand left side, ensure that all 5 barb ttings are in

place & straight before connecting cylinder holder or

another test stand.

" Press 2 units together until barb ttings are fully inserted &

ange screw holes align.

# Insert 3 screws: to connect multiple test stands, remove

white gas plugs from all units except farthest right test stand.

Continue adding test stands to right, cylinder holders to left.*

GALAXY® GX2 Automated Test System Quick Start Guide -

Description and Setup

Memory card port provided on test stand is for calibration &

bump record storage; SD or SDHC memory card can be

purchased from MSA or elsewhere.

Test stand Ethernet jacks

1 System Components

! Touch screen display

" Status LED

# Test stand to test stand connector

% SD card port

$ USB port

& Gas plugs

If using MSA cylinder holders, left-most cylinder holder should

have fresh air lter attached to top port.

*If using ammonia or chlorine test gas, read restriction found under instruction manual chapter 2.8 “Special Conditions for Use with

Reactive Gases” .

GB/EN

Other manuals for MSA galaxy GX2

Questions and Answers:

Need help?

Do you have a question about the MSA galaxy GX2 and is the answer not in the manual?

General