MSA Ultima XE - User Manual

Ultima
®
X Series Gas
Monitors
instruction manual
"
WARNING
THIS MANUAL MUST BE CAREFULLY READ BY ALL INDIVIDUALS WHO
HAVE OR WILL HAVE THE RESPONSIBILITY FOR USING OR SERVICING THE
PRODUCT. Like any piece of complex equipment, the unit will perform as
designed only if it is installed, used and serviced in accordance with the
manufacturer’s instructions. OTHERWISE IT COULD FAIL TO PERFORM AS
DESIGNED AND PERSONS WHO RELY ON THIS PRODUCT FOR THEIR
SAFETY COULD SUSTAIN SEVERE PERSONAL INJURY OR DEATH.
The warranties made by Mine Safety Appliances Company with respect to the
product are voided if the product is not used and serviced in accordance with
the instructions in this manual. Please protect yourself and others by following
them. We encourage our customers to write or call regarding this equipment
prior to use or for any additional information relative to use or repairs.
In the U.S., to contact your nearest stocking location, dial toll-free 1-800-MSA-INST.
To contact MSA International, dial 1-412-967-3354.
This manual is available on the internet at www.msanet.com
© MINE SAFETY APPLIANCES COMPANY 2005 - All Rights Reserved
Manufactured by
MSA INSTRUMENT DIVISION
P.O. Box 427, Pittsburgh, Pennsylvania 15230
(L) Rev 3 10036101

Summary

MSA Instrument Warranty

Warranty

Details the product warranty terms, conditions, and exclusions.

Exclusive Remedy

General Warnings and Cautions

WARNING

Critical safety instructions for installation, operation, and maintenance.

Chapter 2 Start-up and Calibration

Initial Start-up

Calibration Basics

Discusses best practices for calibrating the gas monitor.

Chapter 3 Specifications

Performance Specifications

Lists technical performance data for the gas monitors.

Sensor Response to Interferants

Chapter 1 Installation

Installing Your Gas Monitor

Covers the physical installation process for the gas monitor.

Electrical Connections for Ultima X Gas Monitors

Wiring for all Models

Installing the Ultima X Remote Sensor Module

Electrical Connections for the Ultima X Series Remote Sensor Module

Details wiring for remote sensor modules.

Ultima X Series Gas Monitor Calibration Procedure

INITIAL Calibration

Regular Calibration

Zeroing

Chapter 4 Maintenance

Ultima XIR Cleaning Procedure

Replacing an Ultima XE or Ultima XA Sensor

Obtaining Replacement Parts

MSA Ultima XE Specifications

General

Display	LCD
Ingress Protection	IP66/67
Enclosure	Explosion-proof
Output	4-20mA, HART
Housing Material	Stainless steel