En-15
MS-7599 Mainboard
English
Serial ATA Connector: SATA1~8
This connector is a high-speed Serial ATA interface port. Each connector can connect
to one Serial ATA device.
* The MB layout in this gure is for reference only.
SATA5_6
SATA7_8
SATA1~6 (3Gb/s)
supported by AMD
®
SB710
SATA7/ SATA8 (6Gb/s)
supported by Marvell
®
88SE9128 (optional)
SATA1_2
SATA3_4
Important
Please do not fold the Serial ATA cable into a 90-degree angle. Otherwise, data loss
may occur during transmission.
Please note that setting the “PCI Express x4/x1 Slot” as [x4] under “Integrated Pe-
ripherals” in BIOS will disable the SATA 6 Gb/s ports (SATA7~8) and PCIE x1 slot
(PCI_E1).
Chassis Intrusion Connector: JCI1
This connector connects to the chassis intrusion switch cable. If the chassis is opened,
the chassis intrusion mechanism will be activated. The system will record this status
and show a warning message on the screen. To clear the warning, you must enter the
BIOS utility and clear the record.
•
•
To Next Page
Loading...
