MSI 890GXM-G65 series - Page 62

3-22
BIOS Setup ▍
MS-7642
BIOS Setup ▍
MS-7642
CPU Core Control
Ths tem allows you to select the number of actve processor cores.
OC Gene Lte
Ths tem s bult for auto detectng the overclockng speeder of CPU and GPU for cur
-
rent settng. When t set to [wth GPU], the onboard ntegrated GPU frequency wll set
to 800 MHz automatcally.
Memory-Z
Press <Enter> to enter the sub-menu and the followng screen appears.
DIMM1~4 Memory SPD Informaton
Press <Enter> to enter the sub-menu. The sub-menu dsplays the nformaton of
nstalled memory.
Advance DRAM Con󰘰guraton
Press <Enter> to enter the sub-menu and the followng screen appears.
DRAM Tmng Mode
Ths 󰘰eld has the capacty to automatcally detect all of the DRAM tmng.
DRAM Drve Strength
Ths tem allows you to control the memory data bus’ sgnal strength. Increasng the
drve strength of the memory bus can ncrease stablty durng overclockng.
DRAM Advance Control
Ths 󰘰eld has the capacty to automatcally detect the advanced DRAM tmng. If you
set ths 󰘰eld to [DCT 0], [DCT 1] or [Both], some 󰘰elds wll appear and selectable.
1T/2T Memory Tmng
Ths tem controls the SDRAM command rate. Select [1T] makes SDRAM sgnal
controller to run at 1T (T=clock cycles) rate. Selectng [2T] makes SDRAM sgnal
controller run at 2T rate.
DCT Unganged Mode
Ths feature s used to Integrate two 64-bt DCTs nto a 128-bt nterface.
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶