Appendix B
B-9
AMD RAID
Installing OS on 2.2TB RAID
If you plan to install 64bit operating system on a RAID volume greater than 2.2TB, you
can only manually create and load the RAID array in EFI shell.
WARNING
Create raid array will erase all the data stored on hard drives! Make sure to back up
The following describes an example of how to install Windows 7/ 8 64bit on a RAID 0
volume greater than 2.2TB.
2. Set the “SATA Mode” option to “RAID Mode”.
3. Set the “Board SATA RAID ROM” option to “UEFI DRIVER”.
4. Save and then reboot. Press F11 while system booting to access boot device
selecting menu.
5. Select “UEFI: Built-in EFI Shell” to access the EFI Shell environment.
items.
Shell> drvcfg
Drv[40] Ctrl[B2] Lang[eng]
7. Refer to the value in [Drv] and [Ctrl], Type example “drvcfg -s 40 b2”.
Shell> drvcfg -s 40 b2
8. The RAID ROM will be loaded.
To Next Page
Loading...
