■ Stripe Block Size, the default 64KB is best for most applications. RAID 0 or 10
only.
■ Gigabyte Boundary, allows use of slightly smaller replacement drives.
3. On the Drives Assignments window, use the arrow key to choose the hard
drives which you want to make part of the LD, use the space key to change the
assignment to “Y”. Then press [Ctrl+Y] to save the conguration.
4. A message will show, press [Ctrl + Y] to input a LD name as your desire or press
any key to save default LD name.
5. Another message will show, press [Ctrl-Y] if you are sure to erase the MBR data
of the disk. Or press any key to ignore this option.
To Next Page
Loading...
