6. The message will show up on the bottom, press any key to use maximum capacity
or press [Ctrl-Y] to modify array capacity manually.
Important
•
The default capacity is the full capacity of the selected hard drives.
•
If you allocate the rst LD capacity manually, you can create second LD with
remaining capacity of the selected hard drives.
7. The LD creation is done, the screen shows the LD information as below. Press
ESC key to the main screen.
8. Press ESC key to exit the utility, a message “System is going to REBOOT! Are
You Sure?” will display, answer “Y” to exit it and the system will reboot.
To Next Page
Loading...
