The message wll show up on the bottom, press any key to use maxmum capacty
or press [Ctrl-Y] to modfy array capacty manually.
6.
The LD creaton s done, the screen shows the LD nformaton as below.Press ESC
key to the man screen.
7.
Important
The default capacty s the full capacty of the selected hard drves.
If you allocate the rst LD capacty manually, you can create second LD wth reman-
ng capacty of the selected hard drves.
•
•
Press ESC key to ext the utlty, a message “System s gong to REBOOT! Are You
Sure?” wll dsplay, answer “Y” to ext t and the system wll reboot.
8.
To Next Page
Loading...
