3-20
MS-6738 Micro ATX Mainboard
ECP Mode Use DMA
The ECP mode has to use the DMA channel, so choose the onboard
parallel port with the ECP feature. After selecting it, the following message
will appear: “ECP Mode Use DMA.” At this time, the user can choose
between DMA channel 3 or 1.
Init Display First
This item specifies which VGA card is your primary graphics adapter. Settings:
PCI Slot and AGP.
OnChip USB Controller
This setting is used to enable/disable the on-chip USB controller. Setting
options: All Disabled, All Enabled.
USB 2.0 Controller
This item is used to enable or disable the USB 2.0 supports. Settings: Enabled,
Disabled.
USB Legacy KB/MS Support
Set to Enabled if your need to use a USB keyboard/mouse in the operating
system that does not support or have any USB driver installed, such as DOS
and SCO Unix.
To Next Page
Loading...
Need help?
General
