45
Overview of Components
JSLOW1: Slow Mode Booting Jumper
This jumper is used for LN2 cooling solution, that provides the extreme overclocking
conditions, to boot at a stable processor frequency and to prevent the system from
crashing.
JLN1: Low Temperature Booting Jumper
This jumper is used for liquid nitrogen cooling system to boot at an extreme low
temperature. Try to set it Enabled to increase the boot success rate.
Normal
(Default)
Normal
(Default)
Enabled
(Please enable this jumper
during BIOS POST.)
Enabled
(Please enable this jumper
during BIOS POST.)
Important
y
Users will try extreme low temperature (must be higher than -124 degrees to prevent
Debug Code 00) overclocking at their own risks.
y
The overclocking results will vary according to the CPU version.
y
Please don’t set to Enabled when the system is powered off or can’t be started.
T_SEN1~2: Thermal Sensor Connectors
These connectors allow you to connect the thermistor cable and use it to monitor the
temperature of the detection point.
Thermistor cable
GND
Sense
JSLOW1
JLN1
To Next Page
Loading...
