23
Rear I/O Panel
Rear I/O Panel
ā Clear CMOS button - Power off your computer. Press and hold the Clear CMOS
button for about 5-10 seconds to reset BIOS to default values.
LAN Port LED Status Table
Link/ Activity LED
Status Description
Off No link
Yellow Linked
Blinking Data activity
Speed LED
Status Description
Off 10 Mbps connection
Green 100/1000 Mbps connection
Orange 2.5 Gbps connection
2.5 Gbps LAN
DisplayPort
USB 3.2 Gen 1
5Gbps Type A
Line In
Line Out
Mic In
Clear CMOS
button
Wi-Fi Antenna
connectors
USB 2.0
USB 3.2 Gen 2
10Gbps Type A
Thunderbolt 4
(USB-C)
Mini DisplayPort
Input (for Thunderbolt
passthrough)
Audio 7.1-channel Configuration
To configure 7.1-channel audio, you have to connect front audio I/O module to JAUD1
connector and follow the below steps.
1. Click on the Realtek Audio Console > Advanced Settings to open the dialog below.
2. Select Mute the rear output device, when a front headphone plugged in.
3. Plug your speakers to audio jacks on rear and front I/O panel. When you plug into
a device at an audio jack, a dialogue window will pop up asking you which device is
current connected.
To Next Page
Loading...
