Chapter 3
3-10BIOS Setup 3-11 BIOS Setup
Ipv6 PXE Support [Enabled]
When “Enabled”, the system UEFI network stack will support Ipv6 protocol. This item
will appear when “Network Stack” is enabled.
[Enabled] Enables the Ipv6 PXE boot support.
[Disabled] Disables the Ipv6 PXE boot support.
SATA Mode [AHCI Mode]
Sets the operation mode of the onboard SATA controller.
[Disabled] Disables the SATA function.
[IDE Mode] Specify the IDE mode for SATA storage devices.
[AHCI Mode] Specify the AHCI mode for SATA storage devices. AHCI (Advanced
the speed and performance of SATA storage device, such as Native
Command Queuing (NCQ) and hot-plugging.
[RAID Mode] Enables RAID function for SATA storage devices.
SATA X Hot Plug [Disabled]
Allows user to enable or disable the SATA hot plug support. This item will appear
when the “SATA Mode” set to [AHCI]/ [RAID].
[Enabled] Enables hot plug support for the SATA ports.
[Disabled] Disables hot plug support for the SATA ports.
External SATA 6Gb/s Controller Mode [AHCI]
Sets the operation mode of the external SATA controller.
[Disabled] Disables the SATA function.
[IDE] Specify the IDE mode for SATA storage devices.
[AHCI] Specify the AHCI mode for SATA storage devices. AHCI (Advanced
the speed and performance of SATA storage device, such as Native
Command Queuing (NCQ) and hot-plugging.
HD Audio Controller [Enabled]
HPET [Enabled]
Enables or disables the HPET (High Precision Event Timers) support.
Adjusts integrated graphics settings for optimum system. Press <Enter> to enter the
sub-menu.
Initiate Graphic Adapter [PEG]
Selects a graphics device as the primary boot device.
[IGD] Integrated Graphics Display.
[PEG] PCI-Express Graphics Device.
Integrated Graphics Share Memory [default]
64M, 128M, 256M, 512M, 1024M]
To Next Page
Loading...
