CHAPTER 2 HARDWARE INSTALLATION
2-22
2.17 Power Saving LED Connector: JGL1
JGL1 can be connected with an LED. There are two types of LED that you
can use: 3-pin LED or 2-pin LED(ACPI request). When the 2-pin LED is
connected to JGL1, the light will turn green, when system is On. During
sleep mode, the 2-pin LED will change color from Green to Orange. For 3-pin
LED, when LED is connected to JGL1, this will light when the system is On
and blinks when it is in suspend/sleep mode. See page 3-19 (Power status
LED) for further instruction.
3-pin LED 2-pin LED
1
3
Green Color
Orange
Color
1
3
Green Color
Orange
Color
1-2 Single Color 1-2 Dual Color
1-3 Blink
JGL1
+
1
3
To Next Page
Loading...
