Chapter 3
3-26
suspend state.
Wake Up Events
Press <Enter> to enter the sub-menu and the following screen appears:
USB Resume from S3/S4/S5, VGA, LPT & COM I/O Access, HDD & FDD I/
O Access, PCI Master, PowerOn by PCI Card, Wake Up On LAN/Ring, IRQ
Wake Up Event
These items specify whether the system will be awakened from power saving
modes when activity or input signal of the specified hardware peripheral or
component is detected.
Note: To use the function of Wake Up On LAN/Ring, you need to install a
LAN card/modem supporting power on function.
RTC Alarm Resume
This is to enable or disable the feature of booting up the system on a
scheduled time/date. Settings are Enabled and Disabled.
Date (of Month)
Specifies the date for RTC Alarm Resume. Settings are 0~31.
Resume Time (hh:mm:ss)
Specifies the time for RTC Alarm Resume. Format is <hour><minute>
<second>.
Wake Up Events
USB Resume from S3/S4/S5 Disabled
VGA OFF
LPT & COM I/O Access LPT/COM
HDD & FDD I/O Access ON
PCI Master OFF
PowerOn by PCI Card Disabled
Wake Up On LAN/Ring Disabled
RTC Alarm Resume Disabled
Date (of Month) 0
Resume Time (hh:mm:ss) 0 0 0
IRQ Wake Up Event ON
IRQs Activity Monitoring Press Enter
Item Help
Menu Level 88
x
8
x
To Next Page
Loading...
