AWARD
®
BIOS Setup
3-25
V/H SYNC+Blank This selection will cause the system toturn
off the vertical and horizontal synchroniza-
tion ports and write blanks to the video
buffer.
Blank Screen This option only writes blanks to the video
buffer.
DPMS Support Initial display power management signaling.
MODEM Use IRQ
Name the interrupt request (IRQ) line assigned to the modem (if any) on your
system. Activity of the selected IRQ always awakens the system. Settings
are 3, 4, 5, 7, 9, 10, 11 and NA.
Soft-Off by PWRBTN
This feature allows users to configure the power button as a normal power-
on/-off button or a soft-off button. Settings are:
Instant-Off The power button functions as a normal power-on/-
off button.
Delay 4 Sec. Pressing the power button for more than 4 seconds
will place the system in a very low-power-usage
state (Soft-Off state), with only enough circuitry
receiving power to detect power button activity or
Wake Up On LAN/Ring activity.
State After Power Failure
This item specifies whether your system will reboot after a power failure or
interrupts occurs. Available settings are:
Off Leaves the computer in the power off state.
On Reboots the computer.
Auto BIOS automatically determines the best mode.
LED In Suspend
This item sets how the system uses Power LED on the case to indicate the
suspend state. Settings are:
Blink The Power LED blinks to indicate the suspend state.
Single The Power LED remains the same color.
Dual The Power LED changes its color to indicate the
To Next Page
Loading...
