3-16
MS-6585 ATX Mainboard
min, 30 min.
Hard Disk Time Out
If hard disk activity is not detected for the length of time specified in this field,
the hard disk drive will be powered down while all other devices remain active.
Setting options: Disabled, 1 min, 2 min, 5 min, 10 min, 15 min.
After AC Power Lost
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
Power Off Leaves the computer in the power off state.
Power On Reboots the computer.
Last State Restores the system to the previous status before power
failure or interrupt occurred.
Set WakeUp Events
Press <Enter> and the following sub-menu appears.
Resume On CNR, Wake Up On PME#, Resume On PS2 Mouse From
S3
These fields specify whether the system will be awakened from power
saving modes when activity or input signal of the specified hardware
peripheral or component is detected. Settings: Enabled, Disabled.
To Next Page
Loading...
