En-13
English
Infrared Module Connector
This connector allows you to connect to infrared module and is compliant with Intel
®
Front Panel I/O Connectivity Design Guide. You must configure the setting through the
BIOS setup to use the infrared function.
Serial Port Connector
This connector is a 16550A high speed communication port that sends/receives 16
bytes FIFOs. You can attach a serial device.
6
5
2
1
NC
VCC5
IRTX
NC
Ground
IRRX
16
17
1
5
6
DCD
SIN
SOUT
DTR
Ground
DSR
RTS
CTS
RI (9)
Select eSATA Port / PCI_E1 Slot Jumper: J1, J2 (optional)
The eSATA port shares controller with the PCI_E1 slot. These jumpers allow you to
select either eSATA port or PCI_E1 slot to enable the deivce installed on it.
J1
J2
J1
J2
Enable the PCI_E1 slot. Disable the eSATA port.
Enable the eSATA port. Disable the PCI_E slot.
18
To Next Page
Loading...
