MSI NF980-G65 - Motherboard - ATX - Nvidia Sli Technology

2-22
Hardware Setup ▍
MS-7612
Hardware Setup ▍
MS-7612
NVIDIA
®
SLI Technology
NVIDIA
®
SLI (Scalable Lnk Interface) technology allows two/ three GPUs to run n
tandem wthn a system to acheve up to twce the performance of a sngle graphcs
card. To utlze ths technology, the two GPU cards must be connected by an SLI Vdeo
Lnk card.
SLI Vdeo Lnk Card
If you ntend to use the SLI mode for better graphcs performance, please refer to the
followng nstructons.
Install two graphcs cards on PCI Express x16 slots. Wth two cards nstalled, an
SLI Vdeo Lnk Card s requred to connect the golden 󰘰ngers on the top of these
two graphcs cards (refer to the pcture below). Please note that although you have
nstalled two graphcs cards, only the vdeo outputs on the 󰘰rst card wll work.
Hence, you only need to connect a montor to the 󰘰rst PCI Express card.
1.
SLI Vdeo Lnk Card
Important
The photos shown n ths secton are for demonstraton only. The appearance of your
manboard may vary dependng on the model you purchase.
If you ntend to nstall TWO x16 graphcs cards, make sure that these two graphcs
cards are of the same brand and spec󰘰catons.
Make sure that you connect an adequate power supply to the power connector on the
graphcs card to ensure stable operaton of the graphcs card.
If you ntend to nstall only ONE graphcs card, make sure that the graphcs card s
Installed on the 󰘰rst PCIE x16 (PCI_E2) slot.
•
•
•
•