MSI NF980-G65 - Motherboard - ATX - Completing RAID BIOS Setup

B-6
NVIDIA RAID ▍
MS-7612
NVIDIA RAID ▍
MS-7612
Completng the RAID BIOS Setup
After assgnng your RAID array dsks, press
F7. The Clear dsk data prompt ap-
pears.
1.
Press Y f you want to wpe out all the data from the RAID array, otherwse press
N. You must choose Yes f the drves were prevously used as RAID drves. The
Array Lst wndow appears, where you can revew the RAID arrays that you have
set up.
2.
Use the arrow keys to select the array that you want to set up, then press Enter. The
Array Detal wndow appears.
3.
The Array Detal screen shows varous nformaton about the array that you se
-
lected, such as Strpe Block, RAID Mode, Strpe Wdth, Dsk Model Name, and dsk
capacty.
Press Enter agan to go back to the prevous wndow and then press F10 to ext the
RAID setup. Now that the RAID setup has been con󰘰gured from the RAID BIOS, the
next step s to con󰘰gure and load NVRAID drvers under Wndows, as explaned n
“Installng the NVIDIA MedaSheld Software Under Wndows” on B-8.
4.
5.