MSI Optix MPG341CQR 3DA0 User Manual

2-7
OSD Setup
2-6
1st Level Menu 2nd/3rd Level Menu Description
Anti Motion Blur
(OFF)
■ Brightness cannot be adjusted when Anti
Motion Blur is set to ON�
■ When Anti Motion Blur is enabled, HDCR and
Brightness cannot be enabled and will be
grayed out�
■ Response time will be grayed out while Anti
Motion Blur is enabled�
■ Anti Motion Blur have to set to OFF while
Adaptive Sync is set to ON�
■ PIP/PBP will be disabled while Anti Motion
Blur set to ON�
■ Screen Size will set to Auto if 1:1 is selected.
(ON)
Zero Latency
(OFF)
■ Zero Latency default is ON�
■ Zero Latency helps to reduce the signal
throughput timing�
(ON)
Refresh Rate Location Left Top ■ Users can adjust Refresh Rate in any Mode�
■ Default Refresh Rate Location is Left Top�
Location is adjustable in OSD Menu� Press
the Middle Button to con󰘰rm and apply your
Refresh Rate Location�
■ This monitor follows and works at the
Operating System’s preset Screen Refresh
Rate�
Right Top
Left Bottom
Right Bottom
OFF
ON
Alarm Clock Location Left Top
■ Users can adjust Alarm Clock in any Mode�
■ After setting the time, press the Middle
Button to activate the timer�
■ Default Alarm Clock Location is Left Top�
Users can select their own location�
Right Top
Left Bottom
Right Bottom
OFF
15:00 00:01~99:59
30:00
45:00
60:00
Screen
Assistance
None
■ Users can adjust Screen Assistance in any
Mode�
■ Screen Assistance default is None�
Adaptive Sync
(OFF)
■ Adaptive Sync prevents screen tearing�
■ DisplayPort or HDMI default is ON and can
be adjusted ON/OFF in any mode, any
resolution, any input source and any screen
refresh rate�
■ Anti Motion Blur will be disabled if Adaptive
Sync is enabled�
■ PIP/PBP will be disabled if Adaptive Sync is
enabled�
■ Screen Size will set to Auto if 1:1 is selected.
(ON)

MSI Optix MPG341CQR 3DA0 Specifications

General

Brand	MSI
Model	Optix MPG341CQR 3DA0
Category	Monitor
Language	English