MSI P55A-G55 series - Screw Holes

Hardware Setup
MS-7668
Chapter 2
2-3
Hardware Setup
MS-7668
Chapter 2
Screw Holes
When you install the mainboard, you have to place the mainboard into the chassis in the
correct direction. The locations of screws holes on the mainboard are shown as below.
Refer above picture to install stando󰘯s in the appropriate locations on chassis and then
screw through the mainboard screw holes into the stando󰘯s.
Important
To prevent damage to the mainboard, any contact between the mainboard circuit and
chassis or unnecessary stando󰘯s mounted on the chassis is prohibited.
Please make sure there is no metal components placed on the mainboard or within
the chassis that may cause short circuit of the mainboard.
•
•
Screw holes
The side has to toward
the rear, the position
for the I/O shield of the
chassis.