MSI Z170A PC MATE - Page 44

44
BIOS Setup
▶Super IO Con󰄈guration
Sets system Super I/O chip parameters including LPT and COM ports. Press <Enter>
to enter the sub-menu.
▶Serial (COM) Port 0 Configuration
Sets detailed con󰘰guration of serial(COM) port x. Press <Enter> to enter the sub-
menu.
▶Serial (COM) Port 0 [Enabled]
Enables or disables serial (COM) port x.
▶Serial (COM) Port 0 Settings [Auto]
Sets serial port x (COM). If set to Auto, BIOS will optimize the IRQ automatically or
you can set it manually.
▶Parallel (LPT) Port Configuration
Sets detailed con󰘰guration of parallel port (LPT). Press <Enter> to enter the sub-
menu.
▶Parallel (LPT) Port [Enabled]
Enables or disables parallel(LPT) port.
▶Parallel (LPT) Port Settings [Auto]
Sets parallel port (LPT). If set to Auto, BIOS will optimize the IRQ automatically or
you can set it manually.
▶Device Mode [STD Printer Mode]
Selects an operating mode for parallel port.
[STD Printer Mode] Printer port mode
[SPP] Standard Parallel Port mode
[EPP-1.9/ 1.7 + SPP] Enhanced Parallel Port-1.9/ 1.7 mode + Standard
Parallel Port mode.
[ECP] Extended Capability Port mode
[ECP + EPP-1.9/ 1.7] Extended Capability Port mode + Enhanced Parallel
Port-1.9/ 1.7 mode.
▶Power Management Setup
Sets system Power Management of EuP2013 and AC Power Loss behaviors. Press
<Enter> to enter the sub-menu.
▶EuP 2013 [Disabled]
Enables or disables the system power consumption according to EuP2013
regulation.
[Enabled] Optimize the system power consumption according to EuP 2013
regulation. It will not support S4 & S5 wake up by USB, PCI and
PCIe devices.
[Disabled] Disables this function.