EasyManua.ls Logo

MSI Z97M GAMING - Boot

MSI Z97M GAMING
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-14BIOS Setup 3-15 BIOS Setup
Chapter 3
3-14BIOS Setup 3-15 BIOS Setup
Date (of month) Alarm/ Time (hh:mm:ss) Alarm
Sets RTC alarm date/ Time. If Resume By RTC Alarm is set to [Enabled], the
system will automatically resume (boot up) on a specified date/hour/minute/second
in these fields (using the <+> and <-> to select the date & time settings).
Resume By PCI-E Device [Disabled]
Disables or enables the system wake up by PCI express device.
[Enabled] Enables the system to be awakened from the power saving modes
when activity or input signal of PCIe device is detected. Note:
enables this Item to support “Resume from S3 by USB Device” with
third party USB 3.0 port.
[Disabled] Disables this function.
Resume By USB Device [Disabled]
Disables or enables the system wake up by USB devices.
[Enabled] Enables the system to be awakened from sleep state when activity
of USB device is detected.
[Disabled] Disables this function.
Important
For MB with USB Power Jumpers, you will need to set the jumpers to enabled .
Resume From S3/S4/S5 by PS/2 Mouse [Disabled]
Disables or enables the system wake up by PS/2 mouse.
[Enabled] Enables the system to be awakened from S3/ S4/ S5 state when
activity of PS/2 mouse is detected.
[Disabled] Disables this function.
Resume From S3/S4/S5 by PS/2 Keyboard [Disabled]
Disables or enables the system wake up by PS/2 keyboard.
[Any Key] Enables the system to be awakened from S3/ S4/ S5 state when
activity of any key on PS/2 keyboard is detected.
[Hot Key] Enables the system to be awakened from S3/ S4/ S5 state when
activity of hot key on PS/2 keyboard is detected.
[Disabled] Disables this function.
Boot
Sets the sequence of system boot devices.
Full Screen Logo Display [Enabled]
Enables or disables to show the full screen logo while system POST.
[Enabled] The OS boots straight to the GUI without showing the POST screen.
[Disabled] Shows the POST messages at booting.
GO2BIOS [Disabled]
Enables or disables the system to power on and go to the BIOS setup directly by long
pressing the power button about 4 seconds when the system is off.
[Enabled] The system boots straight to the BIOS setup by long pressing the power
button about 2~4 seconds when the system is off.
[Disabled] Disables this function.

Table of Contents

Related product manuals