EasyManuals Logo

MTD 11A-020B006 User Manual

MTD 11A-020B006
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
Troubleshooting
Problem
Engine Fails to start
Engine runs erratic
1.
2.
3.
4.
Cause
Blade control disengaged. 1.
Spark plug boot disconnected. 2.
Fuel tank empty or stale fuel. 3.
Engine not primed (if equipped with primer). 4.
Remedy
Engage blade control.
Connect wire to spark boot.
Filltank with clean, fresh gasoline.
Prime engine as instructed in the Operation
section.
5. Faulty spark plug.
6. Blocked fuel line.
7. Engine flooded.
8. Fuel valve (if equipped) closed.
5. Clean, adjust gap, or replace.
6. Clean fuel line.
7. Wait a few minutes to restart, but do not
prime.
8. Open fuel valve. See engine manual.
9.
1.
2.
Engine not choked (if equipped with choke). 9.
Spark plug boot loose. 1.
Blocked fuel line or stale fuel. 2.
3. Ventin gas cap plugged. 3.
4. Water or dirt in fuel system. 4.
5,
6.
Dirty air cleaner. 5.
Unit running with CHOKE (if equipped) 6.
Choke engine. See engine manual.
Connect and tighten spark plug boot.
Clean fuel line; fill tank with clean, fresh
gasoline.
Clear vent.
Drain fuel tank. Refill with fresh fuel.
Refer to engine manual.
Push CHOKE knob in.
applied.
Engine overheats 1. Engine oil level low. 1. Fill crankcase with proper od.
2. Air flow restricted. 2. Clean area around and on top of engine.
Occasional skips 1. Spark plug gap too close. 1. Adjust gap to .030".
(hesitates) at
high speed
Idles poorly 1. Spark plug fouled, faulty, or gap too wide. 1.
2. Dirty air cleaner. 2.
Excessive Vibration 1. Cutting blade loose or unbalanced. 1.
2. Bent cutting blade. 2.
Mower will not 1. Wet grass. 1.
mulch grass
2. Excessively high grass.
2.
3. Dull blade. 3.
1. Wheels not positioned correctly. 1.
2. Dull blade. 2.
Uneven cut
Reset gap to .030" or replace spark plug.
Refer to engine manual.
Tighten blade and adapter. Balance blade.
See an authorized service dealer.
Do not mow when grass is wet; wait until
later to cut.
Mow once at a high cutting height, then
mow again at desired height or make a
narrower cutting path.
Sharpen or replace blade.
Place all four wheels in same height posttion
(if equipped with individual height adjusters).
Sharpen or replace blade.
17

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MTD 11A-020B006 and is the answer not in the manual?

MTD 11A-020B006 Specifications

General IconGeneral
BrandMTD
Model11A-020B006
CategoryLawn Mower
LanguageEnglish

Related product manuals