Itissuggestedthatthismanualbereadinitsentiretybeforeattemptingtoassembleoroperate.
Keepthismanualina safeplaceforfuturereferenceandfororderingreplacementparts.
NOTE:Locknutscannotbethreadedontoaboltbyhand,a wrenchisrequiredforassembly.This
typeofnutisusedwherevibrationsoccur.
S'tu" and Removethe lawn mower and all parts from the carton. Make certain all parts and literaturehave
v
been removedfrom the carton beforethe carton is discarded.
lustments" Referto "Hardware Pack",Figure1, for hardwareidentification.
NOTE: Referenceto right, left, front and rearof the lawn moweris in relation to the operating
position.
Disconnectand
groundthe spark
plug wire as instruct,
ed in the separate
engine manual i
IMPORTANT
This unit is shipped
WITHOUT GASOLINE
or OIL. After assem-
bly, service engine
with gasolineand
oil as instructedin
the separate engine
manual packedwith
your unit.
_ ATTACHING THE LOWER HANDLE
_ /,_:::_::;_ Shoulder Scr.
_L[,,,,j.2"-4--.438x .160:5/16-18
(738-04033)
8G
Hex Flange
Hex Bolt Locknut
5/16-18 x .75 5/16-18
(710-3008) (712-3004A)
B_ ATTACHING THE UPPER HANDLE
_=_ _ I_ _ Flanged Locknut_--------1_4-- 5/t6-18
"_--_ (712-04063)
_ _ _ _4--Lockwasher
_'-_ _ 5/16" ID
_ 4-- Carriage Bolt (736-0119)
(710-0262)
c_CJ ATTACHING THE STARTER ROPE
_G _ Flanged Locknut
_ 1/4-20
uide _ (712-04064)
X,,,,_,/4- (7"10-1205)
ATTACHING THE CHUTE DEFLECTOR
(_ (_ Carriage Belt _ )/_(_)
I#_ 4-- 1/4-20 x 1.0
(710-0932) Flat Washer
(736-0t73)
@@ Hex Locknut
4-- 1/4-20
(712-0324)
iNSTALLATiON OF WHEELS
1
_Axme Bolts
(738-o533)
!
Ng Ng
_ _- 3/8-16
_ (712-04063)
@ @
Cupped Washer .375 ID x
.87 OD x .063 (736-0t05)
@@@@
Cupped Washer .39 ID
x 1.13 OD (736-0331)
F_ SECURING
THE CABLE
/
_-- Cable Tie
(726-0240)
Figure 1 - Hardware Pack
Tools Required
• AdjustableWrench • 9/16"Wrench
• 7/16"Wrench • 5/8" Wrench
• 1/2"Wrench • 3/4"Wrench
6
To Next Page
Loading...
