Insertpostofcabletiesthatareonlowerhandle
intotheholesprovidedonthelowerhandle.The
holesmaybeontheinsideoroutside.Pullcable
tiestightandcutofftheextra.SeeFigure5below.
Cable Tie
Post on
Cable
Figure 5
AttachingStarterRope
The rope guide is already attached to the right side of
the lower handle of your mower. See Figure 6.
• With the spark plug wire disconnected and
grounded, hold the blade control handle against the
upper handle, and pull the starter rope up to the
rope guide. See Figure 6.
• Slip the rope through the rope guide as shown
below. Tighten the wing nut holding the rope guide
to the upper handle.
Lower Handle
Starter
Rope
Rope
_Wing Nut
AssemblingSoft GrassBag
• Place the bag over the frame (black plastic side is
the bottom of bag). Slip the openings in the side of
the plastic channels on the bag over the hooks on
the grass catcher frame.
• Secure bag to frame by working the plastic
channels on bag over frame as shown in Figure 7B.
All of the plastic channels except the center top of
the bag attach from the outside of bag. The center
top of the bag attaches from inside the bag.
Frame
/
Frame
Assembly
Bag
Plastic
Channels
Figure 7
AttachingGrassCatcher
• Lift the rear discharge door and place the grass
catcher on the pivot rod. Let go of discharge door so
that it rests on the grass catcher. See Figure 8.
Figure 6
GrassCatcherAssembly
NOTE: Make certain the grass bag is turned right side
out before assembling (warning label will be on the
outside).
Partsfor Soft GrassBag
1. Frame Assembly
2. Bag
Figure 8
NOTE: Make sure that the cables are routed to the
outside of the handle when attaching the grass catcher.
To Next Page
Loading...
